TM 9-4110-256-14
4-19. CONDENSER GUARD REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Equipment Conditions:
Refrigeration unit shut down (para 2-7) and power
disconnected.
General Safety Instructions:
Materials/Parts:
WARNING
Lock Washers (10)
1, Appendix G
High voltage and exposed rotating parts are
used in the refrigeration unit. Personal
.
injury can result if power is connected.
a. Removal. Remove 10 bolts (1), lock washers (2), flat washers (3), and condenser guard (4). Discard lock
washers.
b. Installation. Install condenser guard (4), 10 flat washers (3), new lock washers (2), and bolts (1).
Figure 4-14. Condenser Guard
NOTE
FOLLOW-ON MAINTENANCE:
Connect power and put unit back into service.
4-34
