TM 9-4110-258-13
5.30 CONDENSER COIL REPLACEMENT.
This task covers:
a. Removal
b. Installation
INITIAL SETUP
Materials/Parts:
Tools:
Self Locking Nuts (8)
Gloves
11, Appendix G
1, Section III, Appendix B
Lock Washers (2) (Solenoid Valve Bracket)
Equipment Conditions:
1, Appendix G
Refrigeration system discharged (para 5.8) and
Lock Washers (4) (Filter-Drier Base Support)
purged (para 5.9).
1, Appendix G
Both side doors open.
Lock Washers (8) (Discharge Tube Brackets)
4.17). Condenser coil guard removed (para
1, Appendix G
a. Removal.
(1) De-braze two fittings (1) from condenser coil (2) (para 5.10).
WARNING
Coil fins are sharp and can cut hands or fingers. Wear gloves to prevent
personal injury when handling coil.
(2) Remove eight self locking nuts (3), flat washers (4), bolts (5), and condenser coil (2). Discard self locking
nuts.
(3) If condenser fan shroud (6) must be replaced, proceed as follows:
(a) Remove condenser fan (para 4.36).
(b) Remove dehydrator and filter drier clamp (para 5.15).
(c) Remove solenoid valve (liquid line) (para 5.25).
(d) Remove two bolts (7), lock washers (8), and solenoid valve bracket (9). Discard lock washers.
(e) Remove four bolts (10), lock washers (11), and filter-drier base support (12). Discard lock washers.
(f) Remove eight bolts (13) and lock washers (14). Discard lock washers.
(g) Remove four bolts (15) and flat washers (16).
(h) Carefully pull discharge tube brackets (17) away and remove condenser fan shroud (6).
5-55
