TM 9-4120-370-14
TO 35E9-229-1
5-20. COMPRESSOR (B1) - Continued.
Allow heater to cool before touching. Severe burns can result from touching hot
heater.
(2)
Tag and disconnect two heater leads.
Using pliers, remove retaining spring on heater.
(3)
(4)
Spread the heater ends to clear junction box.
Lift heater up and off compressor crankcase
(5)
For F36T2SA, remove heater clip, pull heater from compressor, tag and disconnect heater leads.
(6)
Install new heater as follows:
(7)
(a) Spring heater ends apart and place heater down and around compressor in position on crankcase.
Secure heater on crankcase with retaining spring.
(b) Run leads through the grommet in the compressor junction box.
(c) See tags on the removed heater. Connect healer leads.
(d) For F36T2SA, see tags and connect heater leads, place heater in compressor, and secure with
heater clip.
(e) If this completes the repair, install terminal box cover.
d. Thermostat (S8) replacement. (Refrigerant system discharge is not required.)
(1)
Check to see that the power has been disconnected at the power source and covers have been removed
during access and testing.
Tag and disconnect two thermostat leads.
(2)
Using pliers, bend retaining tabs back.
(3)
(4)
Remove thermostat.
Install new thermostat as follows:
(5)
(a) Insert thermostat and carefully bend retaining tabs back to secure thermostat.
(b) See tags on removed thermostat. Connect thermostat leads.
(c)
If this completes the repair, install terminal box cover.
Heater (HR8) replacement. (Refrigerant system discharge is not required.)
e.
(1) Check to see that the power has been disconnected at the power source and covers have been removed
during access and testing.
5-37