TM 9-4120-370-14
TO 35E9-229-1
5-20. COMPRESSOR (B1) - Continued.
Allow heater to cool before touching. Severe burns can result from touching hot
heater.
(2) Using screwdriver, remove two screws from each of the two heater terminal covers.
(3) Remove two terminal covers.
(4) Tag and disconnect wire leads and jumper.
(5) Using screwdriver, loosen screw in heater band clamp.
(6) Remove band clamp and two heater halves.
(7) Install new heater as follows:
(a) Position heater halves and heater band clamp on compressor.
(b) Using screwdriver, tighten screw in band clamp.
(c) See tags and wiring diagram (Figure 420) and connect wire leads and jumpers.
(d) Remove tags.
(e) Using screwdriver, secure the two terminal covers with four screws.
