TM 9-4120-378-14
CONTROL MODULE-REPAIR/REPLACE.
This task covers removal, disassembly, repair, inspection, test,
4.24
replacement, reassembly and installation.
INITIAL SETUP
Equipment Condition:
MateriaLs/Parts:
Evaporator inlet louver removed
Solder (Item 2, Appendix E)
Flux (Item 15, Appendix E)
Test Equipment:
Remarks
Action
Location/ltem
Control Module
Disconnect power from air conditioner
before removing control module.
Take care not to break or kink
Remove Temperature Selector switch sense bulb
Removal
a.
sensing line (7) while remov-
(1) from top of evaporator fan housing by remov-
ing from mounting place.
ing two clamps (2) attached with two screws (3)
and two Iockwashers (4).
Turn connector post (5) counterclockwise until
b.
post is disengaged.
