TM 9-4120-378-14
4.33 EVAPORATOR MOTOR. - Continued
Action
Remarks
Location/Item
Then check from pin G to pins A, B, E, and F.
Testing
i.
Continued
Removal
a. Remove four cap screws (1) and four lockwash-
ers (2) from underside of base (3).
b. Loosen the setscrew (4) on shaft extension (5)
and remove motor (6).
Installation
a. Set the motor (6) on base (3) with the motor shaft
in the shaft extension (5).
b. Install four cap screws (1) and four Iockwashers
(2) through the underside of the base (3) to se-
cure the motor.
c. Tighten setscrew (4) of shaft extension (5).
See paragraph 4.32.
d. Install evaporator fan assembly.
See paragraph 4.23.
e. Install evaporator drain tubing.
f. Connect the motor electrical connector.
See paragraph 4.18.
g. Install the evaporator inlet louver.
