TM 9-4120-388-14
This task covers:
a. Inspect
b. Removal
c. Installation
lNITIAL SETUP:
Equipment Condition
Rear panel removed (4-31).
a.
Inspect.
(1) Be sure that caps are in place and that threaded connection ends are not damaged. Replace if missing or
damaged.
(2) Check for signs of leakage. Leak test per para 5-10, if leak is suspected.
b. Removal.
(1)
Remove screw, Iockwasher, flat washer, and clamp.
(2)
(3)
Observe position of valve for proper installation.
(4)
Restrain valve body and loosen and disconnect flare nut.
(5)
Remove the valve.