TM 9-4120-395-14&P
4-4.
UNPACKING.
NOTE
The shipping container is of such a design that it may be retained for reuse if frequent
relocation of the unit is anticipated.
a.
Remove shipping container by lifting the container vertically and removing it From the unit. See Figure 4-3.
b.
Remove cushioning and wrapping around the unit and retain if reuse is anticipated.
NOTE
It is recommended that the cabinet be left bolted to the shipping base until it is time to
place the unit in its installed position. All receiving inspection actions can be
conducted without removal from the shipping base.
4-5.
RECEIVING INSPECTION. Perform receiving inspection of the unit as follows.
a.
Inspect the unit For damage incurred during shipment. If the equipment has been damaged, report the
damage on DD Form 6, Packaging Improvement Report.
NOTE
Compressor units that have been turned on their side or top may have damage to the oil system or motor mounts. Since
there may be concealed damage, follow these steps:
(1)
Set unit in upright position and allow to stand for 24 hours.
(2)
Attempt to start compressor.
(3)
If compressor will not start, makes excessive noise, or will not pump, replace unit.
b.
Check the unit against the packing slip to see if shipment is complete. Report all discrepancies in
accordance with the instructions of DA Pam 738-750.
c.
Check to see whether the equipment has been modified.
Section III. INSTALLATION
Para.
Air Conditioner .............................................................................................................................................................. 4-6
Fresh Air Damper.......................................................................................................................................................... 4-7
Ducting ......................................................................................................................................................................... 4-8
High Voltage Field Connections .................................................................................................................................... 4-9
Thermostat.................................................................................................................................................................. 4-10
4-4
