TM 9-4120-399-14
4-42. CONDENSATE DRAIN ASSEMBLY. (Continued).
Installation.
c.
(1) Install hose (11), trap (9), and clarnp (12).
(2) Install two tees (33) and (32), tube (31), two clamps (30) and (29), clamp (34).
(3) Install tube (28), tee (27), and two clamps (26) and (25).
(4) Install two tubes (23) and (24), and two clamps (22) and (21).
(5) Install two elbows (20) and (19), and two clamps (18) and (17).
(6) Install four tubes (8), (7), (6), and (5), and eight clamps (16), (15), (14), (13), (4),
(3), (2), and (1).
(7) Slide trap (9) and lower condensate hose (10) onto upper condensate hose (11) at
the point where the trap is held in place with hose clamp (12) mounted on filter/dryer
(8) Attach condensate drain assembly hoses (8), (7), (6), and (5) onto bottom of
evaporator drain pan and then tighten four clamps (4), (3), (2), and (1).
(9) Install condenser scroll (See para. 4-46).
(10) Install condenser fan (See para. 4-47).
(11) Install condenser motor (See para. 4-45).
(12) Install control module (See para. 4-43).
(13) Install front panel (See para. 4-20).
4-96
