TM 9-4120-399-14
4-42. CONDENSATE DRAIN ASSEMBLY.
This Task Covers:
c. Installation
b. Repair
a. Removal
Initial Setup:
Tools Required
Tool kit, Refrigeration
Material's Required
None
Equipment Condition
Air conditioner shut down and cool.
Front panel removed (See para. 4-20).
Control module removed (See para. 4-43).
Condenser motor removed (See para. 4-45).
Condenser fan removed (See para. 4-47).
Condenser scroll removed (See para. 4-46).
a. Removal.
(1) Loosen four clamps (1), (2), (3), and (4), and remove condensate drain assembly
hoses (5), (6), (7), and (8) from bottom of evaporator drain pan.
(2) Slide trap (9) and lower condensate hose (10) from upper condensate hose (11) at
the point where the trap is held in place with hose clamp (12) mounted on filter/dryer
(3) Remove eight clamps (1), (2), (3), (4), (13), (14), (15), and (16) and four tubes (5),
(6), (7), and (8).
(4) Remove two clamps (17) and (18), and two elbows (19) and (20).
(5) Remove two clamps (21) and (22), and two tubes (23) and (24).
(6) Remove two clamps (25) and (26), tee (27), and tube (28).
(7) Remove two clamps (29) and (30), tube (31), and two tees (32) and (33).
(8) Remove clamps (12) and (34), trap (9), and hose (11).
b. Repair.
Repair is limited to replacement of defective components.
(4-93 blank)/4-94
