TM9-4120-400-14
COMPONENT REFERENCE LIST
ELEC
REF
DESCRIPTION
DES
COMPRESSOR, RECIPROCATING
B1
B2
MOTOR, CONDENSER FAN
MOTOR, EVAPORATOR FAN
B3
C1
CAPACITOR, FILTER
C2
CAPACITOR
CIRCUIT BREAKER, COMPRESSOR
CB1
CIRCUIT BREAKER, CONTROL
CB2
RECTIFIER, SEMICONDUCTOR DEVICE
CR1
TERMINAL STUD (CONTROL MODULE GND)
E1
TERMINAL STUD (JUNCTION BOX GND)
E2
TERMINAL STUD (SYSTEM GND)
E3 AND E4
HEATER ELEMENT
HR1 THRU HR6
J1 AND J11
CONNECTOR, RECEPTACLE, POWER INPUT
J2A AND J2B
CONNECTOR, RECEPTACLE, JUNCTION BOX
CONNECTOR, RECEPTACLE, EVAPORATOR FAN
J3
CONNECTOR, RECEPTACLE, COMPRESSOR
J4
CONNECTOR, RECEPTACLE, CONDENSER FAN
J5
CONNECTOR, RECEPTACLE, POWER INPUT
J6
CONNECTOR, RECEPTACLE, SOLENOID VALVE BY-PASS
J8
CONNECTOR, RECEPTACLE, SOLENOID VALVE EQUALIZER
J9
CONNECTOR, RECEPTACLE, COMPRESSOR
J10
K1
RELAY, TIME DELAY
K2
RELAY, HEATER
RELAY, COMPRESSOR MOTOR
K3
RELAY, CONDENSER FAN
K4
RELAY, PHASE SEQUENCE
K5
L1
VALVE, SOLENOID, BY-PASS
L2
VALVE, SOLENOID, PRESSURE EQUALIZER
P1
CONNECTOR, PLUG, POWER INPUT
P2A AND P2B
CONNECTOR, PLUG, CONTROL MODULE
P3
CONNECTOR, PLUG, EVAPORATOR FAN
CONNECTOR, PLUG, COMPRESSOR
P4
CONNECTOR, PLUG, CONDENSER FAN
P5
CONNECTOR, PLUG, POWER INPUT
P6
P8
CONNECTOR, PLUG, SOLENOID VALVE, BY-PASS
P9
CONNECTOR, PLUG, SOLENOID VALVE EQUALIZER
P10
CONNECTOR, PLUG, COMPRESSOR
S1
SWITCH, ROTARY SELECTOR
S2
SWITCH, TOGGLE
S3
SWITCH, TEMPERATURE CONTROL
S4
SWITCH, HIGH PRESSURE CUTOUT
S5
SWITCH, LOW PRESSURE CUTOUT
SWITCH HEATER CUTOUT
S6
T1
TB1
TERMINAL BOARD, JUNCTION BOX
TB2
TERMINAL BOARD
TB3
TERMINAL BOARD, POWER INPUT
TO ENERGIZE THE UNIT FROM THE AUXILIARY POWER SOURCE (J11).
THE LEADS ORIGINATING FROM TB3-1 , TB3-2, AND TB3-3 MUST BE
CHANGED TO TB3-4, -5, AND -6 RESPECTIVELY.
NOTE: SHEETS 1,2, AND 3 APPLY TO 3 PHASE UNITS ONLY. SEE SHEETS 4,5, AND 6 FOR SINGLE
PHASE UNITS AND SHEET 7 FOR INPUT POWER AND CONTROL CABLE DIAGRAMS.
4-12
