TM 9-4120-401-14
4-5.
INSTALLATION INSTRUCTIONS. - continued
(b) If the J5 connector is to be used, proceed as follows:
Remove top panel from air conditioner.
Disconnect connector P15 from EMI filter connector J15.
Disconnect connector P15A from dummy connector on bulkhead.
Connect connector P15 on dummy connector on bulkhead.
Connect connector P15A to EMI filter connector J15.
Install top panel onto air conditioner.
(2) If it is desirable to mount the control panel in a remote location (in the conditioned space), the following
steps must be taken.
(a) Loosen captive mounting screw. Remove control panel by pulling screw.
(b) Fabricate interconnecting remote control cable to desired length. (See appendix F, figure F-46.)
(c) Secure control panel at new location and connect remote control cable between connector (J6) and
control panel.
