TM9-4120-401-14
FRESH AIR DAMPER AND ACTUATOR. - continued
5-7.
(13) Install actuator plate (19) with screw (16), two spring washers (18), and self-locking nut (17).
(14) Install damper (7) in opening of housing.
(15) Secure damper cover (23) to housing with two screws (4), lock washers (5), and flat washers (6).
(16) Install one nut (15) seven turns onto each end of push-pull control cable (3).
(17) Install ends of cable through openings in housing.
(18) Install outer nuts (15) on push-pull control cable (3) and tighten.
(19) Insert cable (3) ends into mechanical post (2) and blind nut (14).
(20) Install loop clamp (12), spacer (11), screw (8), nut (10), and washer (9).
NOTE
Be sure equal lengths of push-pull control cable extend from ends.
(21) Put actuator plate (19) in center position and tighten screw (13).
