TM 9-4120-401-14
5 - 3 1 . CONDENSER COIL. - continued
When handling coils, wear gloves to avoid cuts and reduce fin damage.
Remove four screws (19) and carefully lift condenser coil (20) out of unit.
(8)
Debraze sight glass tubing connection (21). (See paragraph 5-14.)
(9)
(10) Debraze two receiver tubing connections (22). (See paragraph 5-14.)
(11) Braze sight glass tube connection (21) to new condenser coil (20). (See paragraph 5-14.)
(12) Braze two receiver tubing connections (22) to new condenser coil (20). (See paragraph 5-14.)
(13) Install four new spring nuts (23) onto coil (20).
When handling coils wear gloves to avoid cuts and reduce fin damage.
(14) Carefully place condenser coil (20) into unit and secure with four screws (19).
(15) Braze tubing connection (18). (See paragraph 5-14.)
(16) Aline sight glass to casing hole and service with mounting plate (10), two screws (7), lock washers (8),
and flat washers (9).
(17) Place loop clamp (16) around sight glass tubing and secure with screw (13), spacer post (17), lock
washer (15), and nut (14).
(18) Secure receiver with two clamps (12) and four screws (11).
(19) Install gasket (6) onto connector (5). Install connector into case.
(20) Attach cap (4) to connector (5) and secure cap chain and connector to unit using four sets of
screws (1), lock washers (3), and nuts (2).
NOTE
FOLLOW-ON MAINTENANCE:
Install new refrigerant desiccant dehydrator (para 5-22).
Install condenser end guard (para 4-17).
5-74
