TM 9-4120-401-14
This task covers:
Replace
INITIAL SETUP
Equipment Condition
Tools
Refrigeration Unit Service Tool Kit
Gloves
Use disconnect switch (NOT POWER
CABLE) to disconnect power to unit.
Damage to cable connector pins will
Materials/Parts
result if cable is used.
Disconnect power from power source.
Lock Washers (3)
Lock Washers (4)
Spring Nuts (4)
Personnel Required
Brazing Alloy
Two
Replace.
(1) Remove four sets of screws (1), nuts (2), and lock washers (3).
(2) Remove cap (4) and carefully pull connector (5) into unit. Remove gasket (6).
(3) Remove two screws (7), lock washers (8), flat washers (9), and mounting plate (10).
(4) Remove four screws (11) and two clamps (12).
(5) Remove screw (13), nut (14), lock washer (15), loop clamp (16), and spacer post (17).
5-72