TM 9-4120-402-14
5-32. COMPRESSOR (B1). - continued
(e)
Install new thermostat as follows:
1
Insert thermostat and carefully bend retaining tabs back to secure thermostat.
2
See tags on removed thermostat. Correct thermostat leads.
3
If this completes the repair, install junction box cover.
d.
Install.
WARNING
To avoid injury to personnel, two people are required for following step.
CAUTION
The compressor is supplied with a complete charge of oil. Take care that oil is not lost when
handling and installing compressor.
NOTE
If any refrigeration piping was disconnected with the compressor being replaced, transfer the
piping to the replacement compressor before installing it in the air conditioner. Check to se that
replacement compressor is equipped with a heater, if not, remove heater from old compressor or
replace with new one.
(1)
Lift compressor through the lower front panel opening and position it on base pan.
(2) - Lever or tilt the compressor (6) and install the four rubber washers (7) (*and four bushings (8))between
the mounting feet and base pan.
(3)
Install two flat washers (4) and one rubber washer (5) onto each of four shoulder bolts (3). Insert the
shoulder bolts (3) from beneath the base. Secure with four flat washers (2) and four lock nuts (1).
(4)
Position tubes to compressor connections and wrap wet rags around compressor at connection points.
(5)
Direct flame away from compressor and braze tubing connections. (See paragraph 5-13.)
(6)
Connect electrical connector plug (P14) to connector (J14) on compressor terminal box.
(7)
NOTE
FOLLOW-ON MAINTENANCE:
*Effective for Carrier Compressor only.
5-85