TM 9-4120-407-14
3-5. PREPARATION FOR INSTALLATION. No preparation is necessary if the air conditioner is to be
installed through a typical exterior wall opening and operated as a self-contained unit. For installations
that require remote mounting the control panel, alternate input power connection locations, or removal of the
fabric cover, use the following procedures:
NOTE
provided for reference during installation.
a. Remote Mounting the Control Panel.
(1) Remove control panel per paragraph 3-20.
(2) Secure the control panel in the remote location using appropriate hardware and bracket.
(3) If the control cable will be routed through the return air opening, use the following procedures:
( a ) Remove the lower front panel per paragraph 3-14.
(b) Disconnect the logic box input P1 connector (l), Figure 3-3 and connect it to the J13 connector (2).
Figure 3-2. Power and Control Connections
(c) Install the lower front panel per paragraph 3-14.
Alternate Input Power Cable Connector Locations.
b.
(1) Remove lower front panel per paragraph 3-14.
(2) Remove the input power connector/EMI filter assembly (3) per paragraph 3-28 and leave loose
inside the unit.
(3) If power cable will be routed through the return air opening, disconnect P11A connector (4), and
connect it to the power connector/EMI filter assembly (3) inside the unit.
3-5
