TM 9-4120-407-14
3-5. PREPARATION FOR INSTALLATION. (Cont)
(4) If using alternate power input connector location, use the following procedures:
(a) If using side connection, remove the EMI filter (5) per paragraph 3-28.
over input power connector/EMI filter assembly (2) opening.
(d) Install the J8 connector (7) at the alternate input power connector location.
(e) Connect the P11A connector (4) to the input power connector/EMI filter assembly (3) inside the
unit.
(5) Cover/seal input power connector/EMI filter assembly (3) opening if necessary.
2 (PRIMARY INPUT POWER
CONNECTOR LOCATION)
Figure 3-3. Input Power Connector Locations
c.
Remova1 of Fabric Cover. If
the fabric cover
needs to be
removed, see paragraph 3-12.
3-6