TM 9-4520-260-13
4-12.
DATA PLATES - CONTINUED
4.
IDENTIFICATION PLATE.
Take care not to drill into parts inside heater.
NOTE
You may have to remove heater from its installation for access to this data plate.
Using a .125-inch diameter drill bit, drill out the four old rivets (8) and remove identification plate (9).
INSTALLATION
1.
IDENTIFICATION PLATE.
Install identification plate (9) using four rivets (8).
2.
CAUTION LABEL.
Install caution label (7) to front plate (4).
3.
INSTRUCTION PLATE.
a.
Install instruction plate (6) and secure with four rivets (5).
b.
Install control panel (11) on front plate (4) using two camloc studs (10).
c.
Install front plate (4) to heater case with 11 screws (3).
4.
WIRING DIAGRAM.
Install wiring diagram (1) to side cover. Secure with four rivets (2).
5.
4-18