TM 9-4520-260-13
4-15.
FUEL STRAINER- CONTINUED
INSTALLATION
1.
See Figure 4-10. If necessary, install nipple (4) into
bulkhead fitting (5). Tighten securely.
2.
Thread strainer (3) onto installed nipple (4). Tighten
securely, noting desired installed position shown in
Figure 4-10.
3.
Attach assembled bulkhead fitting (5) and strainer (3),
along with data plate (7) and cap chain (8), to the
heater case with screws (6). Tighten screws
securely. Make sure strainer is positioned as shown
in Figure 4-10. Adjust as needed.
4.
Install elbow (2) into strainer (3). Tighten elbow
securely and position as shown in Figure 4-10.
5.
Install 7-inch hose (1) onto elbow (2) and tighten
securely.
TESTING
1.
Reconnect the power plug.
2.
Start the heater (para 2-10) and check for fuel leaks.
If leaks occur, stop the heater and correct the leaks.
Restart heater; when operation is satisfactory, stop
heater.
Figure 4-10. Replacing Fuel Strainer.
4-23
