TM 9-4520-260-13
4-22. CONTROL PANEL - CONTINUED
Figure 4-19. Control Panel Assembly component Test Points.
5. FUSE HOLDER.
NOTE
The fuse holder on the control panel assembly that is marked SPARE FUSE does not need to be tested.
It is not connected electrically to any other components. It is only used to hold the spare fuse.
a. Push in the cap on the fuse holder (5, Figure 4-19), rotate the cap counterclockwise, and remove it.
b. Remove fuse from fuse holder.
c. Check fuse for continuity using a multimeter set on the OHMS scale. There shall be continuity. Replace a
defective fuse.
4-39
