TM 9-2330-211-14&P
WIRING HARNESS REPAIR (Con't)
4-16.
ACTION
LOCATION
ITEM
REMARKS
REPAIR
NOTE
All wiring harness repairs are similar to the repair covered in
this paragraph.
1.
Wiring harness (1)
Five screws (2),
Using
in. wrench and flat-tip screwdriver,
nuts (4), and
and five clips (3)
unscrew and take off.
Iockwashers (5)
Wiring harness (1)
2.
Five clips (3)
Spread apart and remove.
Wiring harness (1)
3.
Defective wire
a. Cut wire lead (6) at each end of wiring harness
lead (6)
(1) using cutting pliers.
Ensure that correct wire lead (6) is cut and
that enough lead remains to make
connection for repair.
b. Measure length of wiring harness (1) section to
repair and cut new wire to match. Use cutting
pliers.
4.
Wire lead (7) to
Using wire stripper, strip insulation from ends
of wire leads (7 and 9) equal to depth of connector
receptacle and
wire lead (9) to
(10).
light assembly
5.
Replacement wire (8)
a. Using wire stripper, strip insulation from both
ends of replacement wire (8) equal to depth of
connector (10).
b. Lay replacement wire (8) along wiring harness
(1) section to repair. Feed through four grommets
(11).
4-42