TM 9-2330-211-14&P
4-14.
WIRING HARNESS (Con't)
ACTION
ITEM
REMARKS
LOCATION
FOLLOW-ON MAINTENANCE:
Check operation of lights.
Close stowage box doors (para 2-2).
TASK ENDS HERE
WIRE CONNECTORS
4-15.
This Task Covers:
c.
Marker Band Replacement
a.
Male Connector Repair
b. Female Connector Repair
Initial Setup:
Tools/Test Equipment:
Materials/Parts:
Crimping tool
Contact (as required)
Pliers, diagonal cutting
Insulating compound (Item 3, Appendix E)
Screwdriver, flat-tip
Shell (as required)
Stripper, wire, hand
Terminal assembly (as required)
ACTION
ITEM
REMARKS
LOCATION
MALE CONNECTOR REPAIR
Wire lead (4)
Connectors (5 and 6)
Separate halves.
1.
2.
Connector (5)
Shell (3)
Slide up wire lead (4) until clear of contact (1) and
slotted washer (2).
Slip off of wire lead (4).
3.
Slotted washer (2)
Slide off over contact (1).
4.
Wire lead (4)
Shell (3)
Cut off wire lead (4) using cutting pliers. Discard
Wire lead (4)
Contact (1)
5.
contact.
Ensure that enough wire remains to make
connection after repair.
a.
Wiring harness
Wire lead (4)
Using wire stripper, strip insulation at end equal
6.
to depth of new contact (l).
b.
Apply insulating compound to end and slide on
shell (3).
c.
Slide end into new contact (1) and crimp using
crimping tool.
4-38
