TM 9-2330-381-14
NOTE
Torque wrench and socket should be used to hold capscrew, and combination
wrench should be used to hold slotted nut when applying final torque to
connecting link attaching hardware.
3.
Install slotted nut (23) onto capscrew (24). Using a torque wrench, 1-1/8-inch socket, and 1-1/8-inch combination
wrench, torque slotted nut (23) to 205 lb-ft (278 Nm). Tighten slotted nut (23), additionally as required to aline first
available slot with hole in shank of capscrew (24) and install cotter pin (22).
4.
Position connecting link (21) rod end at linkage attaching point on upper suspension arm (4).
5.
Install capscrew (20) from topside through rod end of link assembly (21) and upper suspension arm (4).
NOTE
Torque wrench and socket should be used to hold capscrew, and combination
wrench should be used to hold slotted nut when applying final torque to
connecting link attaching hardware.
Change 1 4-251