TM 11-5895-463-15
Figure 4-9. Blower motor connections and impeller installation diagram.
(1) Loosen the setscrews and slide the
Caution: Be careful not to damage the
locking ring back on the cable.
wires when replacing the receptacle insert
mounting screws.
(2) Remove the clamping bolts and clamp
nuts from the cable clamp.
(3) Secure the cable form by fastening
the cable clip.
(3) Remove the retaining bolts and both
sections of the cable clamp.
(4) Install the cover on the housing.
(5) Position and secure the rear cover on
(4) Slide the enforcement and nylon in
the signal entrance box.
sulator back on the cable.
(5) Remove the contact assembly retain-
c. Removal of 26-Pair Cable Connectors (fig.
ing screws.
4-16).
4-24