TM 55-1925-282-14&P
0025 00
7. Thoroughly clean the interior of the new filter housing (figure 1, item 5) with fresh water and clean rags.
8. Thoroughly clean the filter housing lid (figure 1, item 2) using fresh water and clean rags.
9. Install a new filter element (figure 1, item 11) in the filter housing (figure 1, item 5).
10. Lubricate the O-ring (figure 1, item 12) with silicone compound, and install it on the filter housing lid (figure 1,
item 2).
11. Place the filter housing lid (figure 1, item 2) on top of the filter housing (figure 1, item 5).
12. Place the lid retaining ring (figure 1, item 10) in position over the filter housing lid (figure 1, item 2), and tighten
until snug.
13. Remove the lockouts and tagouts (FM 55-502).
14. OPEN the bleed screw (figure 1, item 1) on the filter housing lid (figure 1, item 2).
15. Perform Fresh Water Flush (WP 0005 00) on the applicable ROWPU.
16. When the filter housing (figure 1, item 5) is full of water, as indicated by a solid stream of water flowing from
the bleed screw (figure 1, item 1), CLOSE the bleed screw.
17. Check the filter housing and its connections for leaks.
18. Return the equipment to the desired readiness condition.
END OF WORK PACKAGE
0025 025304 -3lank
0 0- / 0 b
