TM 9-2320-211-10-1
Pulling in the Load.
e.
FRAME 1
Take up all slack in winch cable (1).
1.
(a)
Place cable tensioner valve control (2) to ON position.
Move WINCH SHIFT control lever (3) to WIND position.
(b)
Place CLUTCH CONTROL lever (4) in ENGAGE position.
(c)
(d)
After all cable slack is taken up, move CLUTCH CONTROL lever (4) to
DISENGAGE position.
Move cable tensioner valve control (2) to OFF position.
(e)
Pull in the load:
2.
Move CLUTCH CONTROL lever (4) to ENGAGE position.
(a)
Pull THROTTLE control (5) out as necessary to keep up engine speed
(b)
while pulling load in.
After load is pulled in, move CLUTCH CONTROL lever (4) to DISENGAGE
(c)
position.
(d)
Twist THROTTLE control a little left or right and push it in when tacho-
meter (6) shows 1000 rpm.
Move WINCH SHIFT control lever (3) to NEUTRAL position.
(e)
TA
053967
