TM 9-2320-211-10
Retracable beam drive shaft wrench is used to turn the retractable beam drive shaft.
13
The wrench is stowed in a bracket on the inside of the left rear door.
Retractable beam drive shaft is turned to expand or retract the van side panels. Turn
14
drive shaft counterclockwise to expand and clockwise to retrtict side panel.
Locking plunger locks retractable beam drive shaft against rotation and secures side
15
panels in either the expanded or retracted position. P uS h locking plunger down
unlock. Push locking plunger up to lock.
Side panel lock secures body side
16
panels in retracted position. Turn
lock shaft 90 counterclockwise to
unlock, and 90 clockwise to lock
side panel.
Side panel lock wrench is used to
17
turn side panel lock. The wrench is
stowed in a bracket on the inside of
the left rear door.
Side door lock handle on right side
18
is turned 90 counterclockwise to
open, and on left side is turned 90
clockwise to open side door.
Side panel lock handle must be
19
released before extending or
retracting side pmels.
Pin and chain assembly secures side panel lock handle in locked position,
20
Toggle clamp is attached to a swivel hook to draw up and hold the sealing edge of the
21
side panel tight against the sealing edge of the roof panel. Pull clamp handle away from
swivel hook to tighten clamp. Pull clamp handle towards swivel hook to release clamp.
Toggle clamp holder post is used to stow toggle clamp.
22
Swivel hook is stowed in niche near upper edge of side panel.
23
TA 066996
