TM 9-2320-279-10-2
M984A1 General Operating Procedures (Cont)
(4)
Start engine (para 2-11b).
(5)
Check that transmission range selector (3 or 3.1) is set to N (neutral).
(6)
Set PTO ENGAGE switch (2) to ON.
(7)
Move winch shift lever (4) to OUT position to pay out small amount of
cable.
(8)
Set winch shift lever (4) to center position.
(9)
Set PTO Engage switch (2) to OFF.
(10)
Remove cotter pin (5) from pin (6).
(11)
Remove pin (6) from clevis (7) and disconnect clevis from tiedown
ring (8).
(12)
Install pin (6) in clevis (7) with cotter pin (5).
Change 7