TM 9-2320-366-10-2
Table 3-2. Troubleshooting (Cont)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
e16a.
ETHER START SWITCH DOES NOT ILLUMINATE (CONT).
(b)
Position main light switch auxiliary lever to PNL BRT (para 2-27c) and observe if FUEL gage
illuminates.
(c)
Position main light switch auxiliary lever to OFF (para 2-27c).
(d)
Position main light switch main selector lever to OFF (para 2-27c).
If FUEL gage illuminates, notify Unit Maintenance.
If FUEL gage does not illuminate, perform Electrical System Troubleshooting e17A. FUEL Gage
Does Not Illuminate.
Check to see if amber warning light switch illuminates.
(a)
Position main light switch main selector lever to SER DRIVE (para 2-27c).
(b)
Position main light switch auxiliary lever to PNL BRT (para 2-27c) and observe if amber warning
light switch illuminates.
(c)
Position main light switch auxiliary lever to OFF (para 2-27c).
(d)
Position main light switch main selector to OFF (para 2-27c).
If amber warning light switch illuminates, notify Unit Maintenance.
If amber warning light switch does not illuminate, perform Electrical System Troubleshooting
e16C. Amber Warning Light Switch Does Not Illuminate.
Check to see if master power switch illuminates.
(a)
Position main light switch main selector lever to SER DRIVE (para 2-27c).
(b)
Position main light switch auxiliary lever to PNL BRT (para 2-27c) and observe if master power
switch illuminates.
(c)
Position main light switch auxiliary lever to OFF (para 2-27c).
(d)
Position main light switch main selector lever to OFF (para 2-27c).
If master power switch illuminates, notify Unit Maintenance.
If master power switch does not illuminate, perform Electrical System Troubleshooting e16D.
Master Power Switch Does Not Illuminate.
Check to see if OIL PRESS gage illuminates.
(a)
Position main light switch main selector lever to SER DRIVE (para 2-27c).
Change 1
