4-16. Light Wiring Harness
a. Removal. Disconnect the taillight cables at
the connectors. Remove the split rubber grommets
from the holes where the harness passes through the
from the screws holding the wiring harness clips in
place on the frame members. Slip the clips off the
wires. Pull out the wiring harness through the holes
in the frame feeding each bell-type connector
through each frame member hole individually.
b. Installation. Thread the wiring harness.
taillight bell-type connectors first, through the
openings in the frame cross members, starting at
the large hole at the right front corner of the frame.
Insert two of the rubber grommets into their
positions in the cross member frame holes. The
grommets are split so that they will slip over the
cables. Slip the harness clips over the harness cables
and fasten the clips to the frame with the screws,
cables to the harness by coupling the connectors
and twisting them to the locked position. In
fastening the connectors make sure that the ter-
minal connector grommet is position so that it
just covers the terminal shoulder. This position is
illustrated in figure 4-8.
Section Vlll. PARKING BRAKES
4-17. Adjustments
of the brake backing plate. Using the engineers
d . Brake ShoesMinor Adjustment Meth-
od (fig. 1-9). Jack up the
vehicle so
that the
wheel
toward the front of the vehicle until the brake shoe
clears the floor. Pull up the hand brake lever one-
strikes the drum; then turning the wheel, release
third of the distance from the fully released
the eccentric until the wheel just turns freely. Hold
position. Loosen the eccentriv lock nuts on the back
the eccentric and tighten the lock nut. Repeat this
4-10