TM9-2330-207-14
MOVE AXLE ON HYDRAULIC DOLLY
STEP 7.
TO FREE ENDS OF SPRINGS FROM
SPRING GUIDE BRACKETS. ROLL
AXLE FROM UNDER SEMITRAILER.
STEP 8.
USING HYDRAULIC DOLLY, ROLL
AXLE UNDER SEMITRAILER SO THAT
ENDS OF SPRINGS FIT INTO SPRING
GUIDE BRACKETS.
INSTALL THREE TORQUE RODS
STEP 9.
REMOVED IN STEP 6.
STEP 10.
SECURE TORQUE RODS WITH SIX
CASTLE NUTS REMOVED IN STEP 5.
INSTALL COTTER PINS REMOVED
STEP 11.
IN STEP 4.
STEP 12.
INSTALL HYDRAULIC LINE AND
CLIPS REMOVED IN STEP 3.
STEP 13.
INSTALL HYDRAULIC LINE TEE
REMOVED IN STEP 2.
STEP 14.
CONNECT FLEXIBLE HYDRAULIC
LINE DISCONNECTED IN STEP 1, AT
REMOVING OR INSTALLING AXLE
TEE AND HYDRAULIC LINES, DIS-
CONNECTED IN STEP l, AT WHEEL
Figure 4-32. Axle replacement (Sheet 3 of 3)
CYLINDER FITTINGS.
4-35. AXLE REPLACEMENT (Cont)
b. Installation.
(1) All Models except M127. Install axles by
following procedures shown in step 8 thru
14 of fig. 4-32; then install wheels (fig.
4-24) .
(2) Model M127.
(a) Follow installation procedures
shown in steps 8 thru 11 of fig.4-32.
(b) Connect flexible air lines at air
chambers (fig. 4-31 ).
4-36. WIPER REPLACEMENT
a. Removal. Using a hammer, drive wiper off
axle. A new wiper will be used for replacement.
Therefore, if necessary, a cold chisel may be used
to cut old wiper off axle.
b. Installation. Install new oil seal wiper on
axle using wiper replacer (fig. 4-33).
