TM9-2330-207-14
NOTE
The key numbers shown below in parentheses refer to figure 4-54.
a. Position shaft pawl (12) on main member (3) and secure with rivet (13).
b. Insert operating shaft through main member (3) and secure with 1/8 X 1 cotter pin (14).
c. Replace cable assembly (1) in operating shaft (15) and secure to pickup member (7) with two U-bolts,
1/4 Iockwashers (10) and 1/4-20NC-2 hex nuts (11) (para. 4-51).
d. Install two wheel-securing studs (8) and 3/4-16NF-2 safety nuts (6] on pickup member (7).
a. Attach main member (3) to right longitudinal frame rail with four 1/2-20NF-3 X 1 cap screws (2),
1/2 Iockwashers (4) and 1/2-20NF-2 hex nuts (5).
b. Raise spare tire and wheel to a carry position (fig. 2-9).
