TM9-2330-207-14
4-59. LANDING LEG (THOMAS) (Cont)
TIE ROD
UPPER LEG
b. Disassembly (fig. 4-55 and 4-56).
NOTE
The key numbers shown below in paren-
theses refer to figure 4-57 unless other-
wise indicated.
(1) Rest upper end of leg on block and
remove one nut and washer from one
end of tie rod.
(2) Withdraw gear box assembly from upper end of leg (fig. 4-56).
Unscrew operating screw assembly.
(3)
Remove adapter collar (2) from upper leg (13) and withdraw lower leg (12) from upper leg. If
(4)
collar binds on leg, use tool in slot to pry open.
1. Felt, sealing
Nut
17.
Operating Screw Assy
25.
Key, Woodruff
2. Collar, adapter
10.
Stop plate, limit
18.
Nut
26.
Screw, operating
3. Screw, rod-to-collar
11.
Pin, retaining
19.
Bevel gear
27.
Oil seal
4. Tie rod
12.
Lower leg
20.
Bearing cone, upper
28.
Screw nut,
5. Screw, rod-to-housing
13.
21.
Upper leg
Bearing cup, upper
operating
6. Lockwasher
14.
22.
Retainer, bearing
Housing, gear box
29. Oil reservoir
7. Nut
15.
23.
Screw, oil hole
Bearing cup, lower
30. Retainer
8. Lockwasher
16.
Lockwasher
24.
Bearing cone, lower
31. Tube
