TM 9-2330-211-14&P
4-13. CLEARANCE LIGHT ASSEMBLIES (Con't)
ACTION
REMARKS
ITEM
LOCATION
REMOVAL OF CLEARANCE LIGHT BODY
NOTE
All clearance light assemblies are removed the same way.
Oniy one light is shown in this paragraph.
Lens retainer (2)
Two screws (3)
Using flat-tip screwdriver, unscrew and take out.
12.
to light body (1)
Take off of iight body (1).
13.
Lens retainer (2)
a. Remove from clip (4).
Light body (1)
14.
Connector halves(12)
b. Pull apart.
to wiring harness (13)
Using cross-tip screwdr ver and 3/8 in. wrench, un-
Light body (1)
Four nuts (1 1),
15.
screw and take out.
to semitrailer
and screws (9)
Guide connector haif (12) through hole (15) and take
16.
Light body (1)
out. Inspect gasket (16) for damage. Replace if
damaged.
INSTALLATION OF CLEARANCE LIGHT BODY
Position gasket (16) at semitrailer. Guide connector
17.
Semitrailer
Light body (1)
half (12) through hole (15) and aline screw holes.
and gasket (16).
cross-tip
using
tighten
and
in
18.
Screw
Four screws (9),
3
screwdriver and /8 in. wrench.
Iockwashers (1O),
and nuts (11 )
TA506845
4-26