TM 9-2330-211-14&P
4-24. CAMSHAFT
This Task Covers:
a.
Removal
Installation
b.
Initial Setup:
Equipment Conditions:
Materials/Parts:
Chock blocks installed (para 2-5).
q
Dry cleaning solvent (Item 13, Appendix E)
q Air released from system (para 3-8).
q Grease (Item 5, Appendix E)
q Wheel and tire assemblies removed (para 3-9).
q Retaining rings (two required)
q Hub and drum assembly removed (para 4-33).
Brakeshoes removed (para 4-21).
Tools/Test Equipment
Slack adjuster removed (para 4-23).
Drift, brass
q
q Hammer, ball-peen
q Screwdriver, flat-tip
ACTION
LOCATION
ITEM
REMARKS
REMOVAL
NOTE
All camshafts are removed the same way. Only one is
covered in this procedure.
Camshafts are right- and left-handed and are not
interchangeable. Mark or identify properly.
1.
Camshaft (12)
Retaining ring (4)
Using flat-tip screwdriver, pull off and discard.
at bushing
bracket (1)
2.
Camshaft (12)
Retaining ring (5)
Using flat-tip screwdriver, pull off and discard.
at rear of spider (7)
TA506876
4-62
