TM 9-2330-211-14&P
4-37.
LANDING GEAR SHOES (Con't)
ACTION
LOCATION
ITEM
REMARKS
4.
Pin (11)
Using hammer and punch, drive out.
Pin (9)
Pull out.
5.
Shoe (4)
Pad assembly (5)
With the aid of an assistant, slide off.
6.
7.
Pad assembly (5)
Screw (7),
Using wrench, unscrew and remove.
Iockwasher (6),
chain (8), and pin (9).
CLEANING
WARNING
Dry cleaning solvent P-D-680 is toxic and flammable. Always
wear protective goggles and gloves, and use only in a
well-ventilated area. Avoid contact with skin, eyes, and
clothes, and DO NOT breathe vapors. DO NOT use near
open flame or excessive heat. The solvent's flash point is
100F - 138F (38C - 59C). If you become dizzy while
using cleaning solvent, immediately get fresh air and
medical help. If solvent contacts eyes, immediately wash
your eyes and get medical aid.
All parts
a. Using brush, remove dirt and debris.
8.
b. Clean in dry cleaning solvent.
c. Wipe dry with clean rags.
INSPECTION AND REPLACEMENT
NOTE
Replace damaged or defective parts as needed.
a. Look for cracks, breaks, and bad dents.
Shoe (4) and
9.
pad assembly (5)
b. Check that bottom is flat.
Pin (11)
Check for cracks, bends, and breaks.
10.
INSTALLATION
Screw in and tighten using wrench.
Pin (9), chain (8),
11.
Pad assembly (5)
lockwasher (6),
and screw (7)
Pad assembly (5)
Put on.
12.
Shoe (4)
Pin (9)
Put in.
13.
Pin (11)
Lower leg (10)
Using hammer and punch, drive in.
14.
Place in position.
Shoe (4) and pad
15.
assembly (5)
4-111
