TM 99-2330-227-14&P
LANDING GEAR HANDCRANK
This task covers:
INITIAL SETUP
Personnel Required
Tools
One
Handle, ratchet, 1/2-inch drive
Socket, 1/2-inch drive, 9/16-inch
Wrench, box-end, 9/16-inch
ACTION
ITEM
REMARKS
LOCATION
NOTE
Both landing gear handcranks are removed and installed the same way. This task is for
one; repeat for the other.
REMOVAL
Screw (3), nut (4),
Using 9/16-inch socket, ratchet handle
1. Shaft (1) and
crank (2)
and two washers (5)
with 1/2-inch drive, and 9/16-inch box-
end wrench, unscrew and take out.
Crank (2)
Take off.
2. Shaft (1)
INSTALLATION
Crank (2)
3.
Put on.
Screw (3), nut (4),
4. Shaft (1) and
Screw in, and tighten using 9/16-inch
and two washers (5)
crank (2)
socket, ratchet handle with 1/2-inch
drive, and 9/16-inch box-end wrench.