TM 9-2330-227-14&P
BRAKESHOE ASSEMBLY REPAIR, TWO-CYLINDER BRAKE ASSEMBLY - CONTINUED
ACTION
LOCATION
ITEM
REMARKS
REPAIR - CONTINUED
16 rivets (3)
1. Brake lining(1)
Using brake reliner, remove.
and brakeshoe (2)
Brake lining (1)
2. Brakeshoe (2)
a. Take off.
b. Using wire brush and drycleaning
solvent, clean brakeshoe (2).
Brakeshoe (2)
3.
a. Check for cracks, breaks in welds,
distortion, warping, and oversize
rivet holes (4).
b. If defective, replace (page 4-84).
NOTE
If drums have been turned, a shim must be used between brakeshoe and lining. Shim
must be the same thickness as the total depth of cut made when turning the drum.
Line up holes.
New brake lining
a.
4. Brakeshoe (2)
(1), shim (5),
Using brake reliner, put in rivets
b.
and 16 rivets (3)
(3), starting in center and working
outward.
c.
Using 0.002-inch (0.051-mm) thick-
ness gage, check fit.
Gage should not penetrate past
rivets.
5-41
