TM 9-2330-227-14&P
BRAKESHOE ASSEMBLY REPAIR, ONE-CYLINDER BRAKE ASSEMBLY OPTION - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REPAIR - CONTINUED
Using brake reliner, remove.
16 rivets (3)
1. Brake lining (1)
and brakeshoe (2)
Take off.
Brake lining (1)
2. Brakeshoe (2)
Place brakeshoe (2) in bed of arbor
a.
Bushing (4)
3.
press.
Using 3-inch brass drift placed be-
b.
tween bushing (4) and ram of press,
drive out.
Get rid of bushing (4).
c.
Using wire brush and drycleaning
d.
solvent, clean brakeshoe (2).
Check for cracks, breaks in welds,
a.
Brakeshoe (2)
4.
distortion, warping, and oversize
rivet holes (5).
b.
Using arbor press, start bushing (4) in
New bushing (4)
5. Brakeshoe (2)
anchor pin hole of brakeshoe (2), and
drive in until flush with face of brake-
shoe (2).
NOTE
If drums have been turned, a shim must be used between brakeshoe and lining. Shim
must be the same thickness as the total depth of cut made when turning the drum.
TA231356
5-43