TM 9-2330-227-14&P
U-BOLTS, RADIUS ROD AND BRACKET, AND SPRING - CONTINUED
ACTION
REMARKS
ITEM
LOCATION
REMOVAL - CONTINUED
With help from assistant, lift off.
Spring (2)
16. Axle (1)
INSTALLATION
With help from assistant, put in position.
Spring (2)
If removed, using ball-peen hammer,
Rubber bumper (4)
Radius rod
tap in.
bracket (3)
If removed, using ball-peen hammer,
Two rubber
tap in place.
bushings (5)
Put in position.
Radius rod (7)
Spring bracket (6)
Coat with grease to keep in place.
a.
Four washers (8)
Radius rod (7)
b.
Position on each side of radius rod (7).
Locate over end of radius rod, and
a.
Radius rod
Spring (2) and
position on spring (2).
bracket (3)
radius rod (7)
b.
Aline U-bolt holes.
Using 1-inch drive-pin punch and ball-
Sleeve
Radius rod (7)
peen hammer, tap in.
bushing (9)
and spring
Make sure setscrew hole in bushing
bracket (6)
lines up with setscrew hole in radius
rod.
Screw in, and tighten using 5/8-inch
Setscrew (10)
Sleeve
socket, 4-inch extension, and ratchet
bushing (9)
handle with 1/2-inch drive.
Place on each side.
Two retainers (11)
Spring bracket (6)
Using ball-peen hammer and 1/2-inch
Screw (12)
Radius rod (7) and
driftpin, tap through.
spring bracket (6)
a.
Screw on, and tighten using 15/16-inch
Nut (13) and
Screw (12)
socket, ratchet handle with 1/2-inch
retaining nut (14)
drive, and 15/16-inch open-end
wrench.
b. Repeat steps 23 thru 27a for other
end of radius rod (7).
a. Take trestle out from under frame (15).
Semitrailer
frame (15)
