TM 9-2330-227-14&P
SPRING BRACKETS - CONTINUED
ACTION
ITEM
REMARKS
LOCATION
INSTALLATION - CONTINUED
Lower semitrailer so spring (2) is
Semitrailer
frame (1)
engaged with spring brackets (3) and (4).
Sleeve bushing (6)
Using 1-inch drive-pin punch and ball-
Radius rod (5) and
peen hammer, tap in.
spring bracket (3)
Make sure setscrew hole in bushing
lines up with setscrew hole in
radius rod.
Screw in, and tighten using 5/8-inch
Setscrew (7)
Sleeve bushing (6)
socket, 4-inch extension, and ratchet
and radius rod (5)
handle with 1/2-inch drive.
Retainers (8)
Place on each side.
Spring bracket (3)
Screw (9)
Using plastic-face hammer, tap through.
Radius rod (5) and
spring bracket (3)
Nut (10) and
Screw on, and tighten using 15/16-inch
Screw (9)
retaining nut (11)
socket, ratchet handle with 1/2-inch
drive, and 15/16-inch open-end wrench.
Two screws (12)
Using plastic-face hammer, tap through.
Spring brackets
(3) and (4)
Two nuts (13)
Screw on, and tighten using 15/16-inch
Two screws (12)
socket, ratchet handle with 1/2-inch
drive, and 15/16-inch wrench.
Two cotter
Put through, and using slip-joint pliers,
Two nuts (13)
pins (14)
bend legs.
Semitrailer
a.
Using hydraulic jack, lower.
frame (1)
b.
Remove hydraulic jack, wood blocks,
and trestle.