TM 9-2330-227-14&P
LEFT REAR DOOR
This task covers:
Repair (page 4-84)
INITIAL SETUP
Materials/Parts
Tools
Adhesive (item 1, appendix E)
Brush, wire
Rivets, blind (as required)
Hammer, ball-been, machinist's, l-lb
Handie, ratchet, l/2-inch drive
Personnei Required
Piiers, siipjoint, straight-nose
Punch, drive-pin, l/16-inch
Punch, drive-pin, l/8-inch
One
Punch, drive-pin, 3/16-inch
Equipment Condition
Screwdriver, cross-tip, number two
Screwdriver, fiat-tip, 3/8-inch
Ladder removed (page 4-183).
Socket, l/2-inch drive, l/2-inch
Left rear door removed (page 4-166).
Wrench, open-end, l/2-inch
ACTION
ITEM
REMARKS
LOCATION
NOTE
Disregard any difference in the number of panel rivets used on your door as compared to
the number shown in this procedure. This may vary.
16 screws (2)
Using number two cross-tip screwdriver,
Four inner
frame strips (1)
take off.
26 rivets (3)
a. Using l/8-inch drive-pin punch and
bail-peen hammer, drive punch through
center of rivet head with a solid biow
of hammer.
Rivet heads will either fall off or
can be lifted off with screwdriver.
b. Using 3/16-inch drive-pin punch and
ball-peen hammer, drive out remaining
part of rivet (3).
Four inner
Lift off.
3. Door(4)
frame strips (1)
Four screws (6)
Using number two cross-tip screwdriver,
unscrew and take out.
