TM 9-2330-235-14&P
4-37. SUSPENSION ARM MAINTENANCE (M514) (Con't).
5. Coat torsion bar (12) with grease. Use a brass drift to drive torsion bar into cover (29).
6. Install support (11) on cover (29).
7. Install stud (14), flat washer (13), new lockwasher (15), nut (16), and new cotter pin (18) on inner end of torsion
bar (12).
8. Install new expansion plug (17) in support (11).
9. Install stud (36), flat washer (35), new lockwasher (37), nut (39), and new cotter pin (38) in outer end of torsion
bar (12).
10. Install new gasket (40) and cover (41) on suspension arm (9) with two new lockwashers (42) and screws (43).
11. Assemble clevis (19), clevis (21), and adjusting screw (25). Install two screws (24) and nuts (20). Do not fully
tighten nuts.
12. Install clevis (19) on support (11) with straight pin (27) and new cotter pin (26).
TA704330
4-87
