TM 9-2330-235-14&P
4-37. SUSPENSION ARM MAINTENANCE (Con't)
13.
Install outer bearing support (48) and
center bearing support (51) on suspension arm (9) with
setscrews (47).
e. INSTALLATION
NOTE
Ensure that outer, center, and inner bearing
supports are installed as marked.
1.
Position
suspension
arm
(9)
for
installation.
Install outer, center, and inner bearing
supports (48, 51, and 52) on support bracket (46) with
eight new lockwashers (49) and screws (50
2. Connect clevis (21) to frame with straight pin (23) and new cotter pin (22).
3. Install nut (7) and clevis (8) on shaft (6). Tighten nut against clevis.
4. Install rubber bushing (5) on shaft (6). Position shaft for installation. Connect clevis (8) to suspension arm (9)
with straight pin (45) and new cotter pin (44).
5. Install rubber bushing (4), two flatwashers (2 and 3), and new locknut (1) on shaft (6).
TA505036
4-88
