TM 9-2330-247-14&P
4-30. HANDBRAKE CABLE AND LEVER ASSEMBLY (Con't)
ACTION
ITEM
REMARKS
LOCATION
14.
Backing plate (35)
Cable assembly (1)
Pull through backing plate (35) and remove.
15.
Two pins (29)
Spring (37)
Using slip-joint pliers, pull off.
16.
Two slotted
a. Using hammer and in. flat-tip screwdriver,
washers (26) and
tap out slotted washers (26).
four washers (27)
b. Pull off washers (27).
Pull off together, then separate.
17.
Brakeshoe lever
(28) and link (30)
INSTALLATION
18.
Brakeshoe lever
a. Push together with opening on link (30) sliding
(28) and link
into pin on back of brakeshoe lever (28).
b. Place in position on two pins (29).
(30)
a. Put two washers (27) on each pin (29).
Four washers
19.
(27) and two
b. Slide slotted washers (26) on pins (29).
slotted washers (26)
c. Tap the rest of the way on using hammer and
in. flat-tip screwdriver.
Put on using slip-joint pliers.
20.
Spring (37)
Feed through hole in backing plate (35).
Cable end (36)
21.
Backing plate
(35)
Hold spring (37) back and push cable end (36) into
Cable end (36)
Brakeshoe
22.
slot on brakeshoe lever (28).
lever (28)
4-51
