TM 9-2330-247-14&P
S e c t i o n Vlll. BRAKE SYSTEM MAINTENANCE
Page
Page
Airbrake Chamber . . . . . . . . . . . . . . . . . . . .
Draincock . . . . . . . . . . . . . . . . . . . . . . . . . .
Air Couplings . . . . . . . . . . . . . . . . . . . . . . . .
Handbrake Cable and Lever Assembly . . .
Air Filters . . . . . . . . . . . . . . . . . . . . . . . . . . .
Hydraulic Tubes and Fittings . . . . . . . . . . .
Air Hoses and Fittings . . . . . . . . . . . . . . . .
Master Cylinder . . . . . . . . . . . . . . . . . . . . . .
Backing Plate . . . . . . . . . . . . . . . . . . . . . . .
Pressure Tank and Relay Valve . . . . . . . . .
Bleeding Brake System . . . . . . . . . . . . . . .
Service Brake . . . . . . . . . . . . . . . . . . . . . . .
Brakeshoe Assembly . . . . . . . . . . . . . . . . .
Wheel Cylinders . . . . . . . . . . . . . . . . . . . . .
HANDBRAKE CABLE AND LEVER ASSEMBLY
This Task Covers:
a.
Removal
b.
Installation
Initial Setup:
Equipment Conditions:
Tools/TestEquipment:
Hub and brakedrum removed (para 4-44).
Hammer, hand, ball-peen, 3 lb
Handle, ratchet, in. drive
Personnel Required: Two
Pilers, slip-joint
Screwdriver, cross-tip, no. 2
Screwdriver, flat-tip, in.
Socket, in. drive,
in.
Socket, in. drive, in.
Socket, in. drive,
in.
Wrench, box-end, in.
Wrench, box-end,
in.
Wrench, open-end,
in.
ACTION
LOCATION
ITEM
REMARKS
NOTE
Both handbrake cable and lever assemblies are replaced in the same way. This
procedure is for the right; repeat for the left.
Ensure that handbrake lever is released before proceeding.
REMOVAL
1.
Clevis pin (22)
Cotter pin (4)
Using slip-joint pilers, straighten and pull out.
2.
Pull out.
Clevis (3)
Clevis pin (22)
Handbrake lever (6)
Two screws (20),
Using
in. socket, ratchet handle with in. drive,
3.
and
in. box-end wrench, unscrew and take off.
bushings (12),
and side front
lockwashers (9),
chassis frame (11)
and nuts (10)
