TM 9-2330-247-14&P
4-30. HANDBRAKE CABLE AND LEVER ASSEMBLY (Con't)
ACTION
ITEM
REMARKS
LOCATION
Backing plate
Pull toward front to remove slack.
Cable assembly
23.
End of cable assembly conduit should
(1)
(35)
touch backing plate (35).
Backing plate
Bracket (32)
Place into position.
24.
Ensure that bracket (32) fits in groove on
studs (31)
cable assembly (1).
Two Iockwashers
25.
in. socket and ratchet
Screw on and tighten using
handle with in. drive.
(33) and nuts (34)
Ensure that bracket (32) lip fits in notch on
cable assembly conduit.
26.
a. Line up cable assembly (1) with screw hole.
Axle offset
Clamp (24) and
b. Put clamp (24) on cable assembly (1) across
beam (23)
cable assembly (1)
from hole.
Leave enough slack so cable assembly (1)
can move as offset beam (23) moves.
27.
Clamp (24) and
Screw in and tighten using no. 2 cross-tip screw-
Screw (25)
driver.
axle offset
beam (23)
a. Lineup cable assembly (1) so conduit end (19) is
28.
Frame (16)
Cable assembly
between holes.
(1) and cable
b. Put cable bracket (18) into position.
bracket (18)
Screw in and tighten using in. socket, ratchet
Two screws (17),
29.
Cable bracket
handle with in. drive, and in. box-end wrench.
(18) and
Iockwashers (15),
and nuts (14)
frame (16)
4-52
