TM 9-2330-271-14&P
Section III. GENERAL MAINTENANCE
outs where required, and secure with screws and
5-4. Wiring Harness
clamps.
(2) Connect harness to receptacles and all
a.
Removal
cable connectors.
(1) Disconnect receptacles from harness and
NOTE
all cable connectors.
Ground wire terminal is secured by one of
(2) Remove four nuts, lock washers and
four screws, lock washers and nuts.
screws securing connector and cover to crossmember
(3) Secure
connector
and
cover
to
and remove connector and cover. Unsolder harness
crossmember with four screws, lock washers and nuts
wire from connector (paragraph 4-15a).
(3) Remove nuts, screws, lock washers and
clamps securing harness to undercarriage, and remove
harness.
5-5. Wiring Harness Connectors and Receptacles
b. Installation.
(1) Position harness, threading through cut-
Refer to figure 5-1 for repair of connectors and
receptacles.
Figure 5-1. Replacement of receptacles and connectors.
c. Cut new piece of wire to same length (plus splice)
5-6. Replacement of Single Wires
as defective wire and splice to harness. Tape splice with
insulating tape. Assemble new terminals, washers,
a. Remove and discard electrical insulating tape
sleeves and connector shells to ends of new wire as
binding wires of defective branch.
required. Install marker band to new wire.
b. Cut defective wire from branch, leaving
sufficient wire for splicing
5-2
