TM 9-2330-271-14&P
Figure 9-2. Air conditioner and remote control unit, XM680,
XM680E1
(2) Disconnect remote control cable at air
(1) Position air conditioner on shock mounts
conditioner end in interior of van.
and secure in place with the screws which run through
(3) Open front doors and latch in place with
the centers of the shock mounts.
stabilizing rods.
(2) Position snubber assembly and secure in
(4) Disconnect power cable, first at top and
place with the stud assemblies.
then at bottom.
(3) Install condensate drain hoses and secure
(5) Stow loose cables in a safe place to prevent
with the hose clamps.
loss or damage during removal of air conditioner.
(4) Connect power and remote control cables.
(6) Loosen
upper
hose
clamps
on
(5) Fasten remote control cable assembly to air
conditioner shock mount with jiffy clip, screw and
washer.
(7) Unscrew snubber assembly holding collars
(6) Place return air grilles into position and
from stud assemblies of each unit allowing snubber
fasten with screws and washers.
assemblies to hang free.
(7) Connect damper control chain.
(8) Remove screws from centers of shock
mounts.
9-5. Remote Control Unit, XM680,
XM680E1
(9) Remove air conditioner unit by sliding it
forward on mounts until it can be grasped and lifted off.
a. Removal.
c. Installation (fig. 92).
(1) Disconnect damper control chain from
9-3